Rheology and Deformation Processes of Fine-grained Quartz Aggregate - INSU - Institut national des sciences de l'Univers Accéder directement au contenu
Communication Dans Un Congrès Année : 2023

Rheology and Deformation Processes of Fine-grained Quartz Aggregate

Résumé

Grain size is a critical parameter for viscous deformation processes and controls the rheological behaviour (weakening and strain localizations in mylonites) of polycrystalline aggregates. Recently, Ghosh et al., (2022) used Tana quartzite (~200 μm) to develop a new grain-size-insensitive flow law (stress exponent, n = 2; activation energy, Q = 110 kj/mol). The n = 2 is interpreted to indicate the serial operation of grain interior (dislocation glide) and grain boundary (dissolution-precipitation, DPC + Grain boundary sliding, GBS) accommodation processes. It is shown that all the previous results obtained from coarse-grained (∼100 - 200 μm) quartz aggregates (high total strain, significant recrystallization) plot within a factor of ∼5 times the strain rate predicted by this flow law. Moreover, a number of earlier studies with fine-grained (3.6 to 12 μm) quartz reported an n-value range of 1.7 to 2.5 (Kronenberg and Tullis 1984; Fukuda et al., 2018), similar to the values obtained from coarse-grained samples. A deviation from the grain-size-insensitive creep-dominated process is expected at those grain-size ranges and poses the question: how much weakening is possible by grain-size-reduction within the continental crust?Using a Griggs-type apparatus, we deformed fine-grained (~ 3-4 μm) as-is and 0.1 wt.% H2O-added novaculites, representing a fully recrystallized shear zone material, at the same condition as coarse-grained Tana quartzite (~200 μm). The as-is novaculite is ~3.5 times stronger than the H2O-added novaculite. A similar strength difference (~4 times) was also observed between the as-is and H2O-added Tana quartzite. The H2O-added novaculite is ~4 times weaker than the H2O-added Tana. The as-is novaculite is ~4.5 times weaker than the as-is Tana quartzite. Thus, the addition of 0.1 wt.% H2O causes a similar order of weakening as the smaller grain size; the as-is novaculite has a similar strength as the data predicted from the H2O-added Tana flow law. The maximum strength difference (more than an order of magnitude) arises between the end-member samples i.e., the as-is Tana and H2O-added novaculite, which indicate the combined effect of grain size and H2O. The n (1.91 to 2.19) and Q (118 kj/mol) values measured from novaculites are similar to the Tana and the Tana flow law can express all the novaculite data within the error associated with the Griggs-type apparatus, only by manipulating the A-value of the flow law. Therefore, the n and Q values are largely grain-size-insensitive, while the strength differences due to grain size and added-H2O can be expressed by varying the A-value. Further, the similarity in the n and Q values indicates that the same deformation mechanisms (i.e., dislocation creep accommodated by grain boundary processes) operate in both materials. Microstructural analysis of the novaculite reveals the development of a core-shell structure of individual grains due to grain boundary migration (GBM). A combination of deformation mechanisms (dislocation glide, GBM, GBS) are mutually dependent and interact to achieve the bulk sample strain. The variations in A-value may reflect the efficiency of the GBS mechanism depending on grain size and H2O content. Finally, the implications of these results on crustal strength will be discussed.
Fichier non déposé

Dates et versions

insu-04182729 , version 1 (18-08-2023)

Identifiants

Citer

Subhajit Ghosh, Holger Stünitz, Hugues Raimbourg, Jacques Précigout. Rheology and Deformation Processes of Fine-grained Quartz Aggregate. EGU23, Apr 2023, Vienne (AUT), Austria. ⟨10.5194/egusphere-egu23-15832⟩. ⟨insu-04182729⟩
20 Consultations
0 Téléchargements

Altmetric

Partager

Gmail Facebook X LinkedIn More